SINK Support / Hanging Assemblies

Under Counter Mount Sink Support, Installation Methods:

The industry standard and accepted method of supporting under mount epoxy resin sinks below Trespa TopLab plus is with steel - epoxy powder coated sink support assemblies attached to the sink cabinets.

A chemical resistant two part epoxy adhesive is applied to the top surface of the epoxy sink rim in order to form a chemical resistant seal between the Duratop epoxy sink and the underside of the countertop. The suggested counter top material is Trespa TopLab plus.

After attaching the sink assembly supports to the two inside walls of the wood or steel cabinets, care should be taken to insure that the 1/4" (6mm) diameter "J" Hook supports are ratcheted up evenly to maintain the intended level of the sink and the natural drainage within the sink slope.

Division 12 specification calls for "epoxy sinks to be supported from below by metal frame and hanger brackets. Frame to consist of two adjustable channels of 11 gauge steel 1" x 2", extending across width of cabinet, and attached to 1/4" to 3/8" diameter threaded hanger rods. Adjustable channels shall have a chemical resistant finish. Use adjustable support system as recommended by the casework or sink manufacturer."

Sink Support sizes available for various sink cabinet interior openings from 18" to 58". Custom sizes are available upon request.